Zhangjiagang Leyu Yiyi Machinery Factory
Service Hotline:18706246515
Banner
Home > news > Content

How to remove the failure of the PE mill

Edit:Zhangjiagang Leyu Yiyi Machinery FactoryUpDate:2019-08-26

Regarding how to remove the problems of the PE mill, it is hoped that it will have some effect on you. What kind of PE mill is a trustworthy product or service, many people have confusion about the PE mill.
How to eliminate the problem of plastic mill?
Finishing problems:
1. Check if the lubrication state of the bearing is outstanding. If the lubrication is insufficient, the lubricant should be added in time to reduce wear and improve mechanical efficiency.
2. Check that all fasteners are tightened to avoid any safety accidents and damage the machine.
3. Check whether the belt is correct and the condition is excellent. If the belt is cracked, it should be replaced in time. When there is oil pollution on the belt or the sheave, wipe the cloth with a clean rag in time to avoid slipping and form it.
4. Check if the protective equipment is outstanding. If there is a hidden danger in the protection equipment, it should be eliminated in time.
5. Check if there is any information or other debris in the damaged cavity, such as timely finishing to ensure a reasonable breaking gap.
6. Check if the hydraulic jack top or top screw is back and adjust the gasket for proper installation and compression.
Problems that should be paid attention to during the use of the rolling mill 1. During the use, there should be a fixed person to serve. It is necessary for the operator to have a certain level of skill. Before the installation, it is necessary for the operator to carry out the necessary technical training to understand the principle and performance of the mill and to be familiar with the operating procedures.
2. In order to make the pendulum mill operate normally, the equipment “equipment maintenance safety operating system” should be set up to ensure the long-term safe operation of the rolling mill. At the same time, the necessary maintenance, grease and corresponding accessories should be used.
3. After a period of time, the overturning mill is overhauled, and the worn parts such as the roller ring scraper are repaired and replaced. Before and after the application of the roller device, carefully check the connecting bolt and nut to see if there is looseness and whether enough grease is added.
4. When the grinding roller is used to replace the grinding roller for more than 500 hours, it is necessary to clean the rolling bearing in the roller sleeve. The damaged parts should be replaced in time, and the fuel can be applied by the manual air pump and the grease gun.

Address:Zhangjiagang Leyu Development Zone  电话:18706246515  MobilePhone:18706246515  E-mail:1360565135@qq.com

Mobile