Zhangjiagang Leyu Yiyi Machinery Factory
Service Hotline:

Troubleshooting method for PE mill

Edit:Zhangjiagang Leyu Yiyi Machinery FactoryUpDate:2019-09-10

Today we introduce the knowledge about the troubleshooting of PE mills. With the continuous development of PE mill technology, PE mills have been gradually loved by manufacturers.
Due to the working environment of the plastic grinding machine, some troubles will occur during the operation of the plastic grinding machine. Then, how to know the failure of the mill is a problem that we are very concerned about now, and the technicians of the plastic mill of our factory have thoroughly studied the mill and finally solved the troubleshooting of the mill.
First, timely protection:
In the process of using machinery, there must be a variety of faults. Among these failures, some of the failures have little impact on the mechanical equipment, and some are very serious, which may lead to severe mechanical accidents. Timely handling of faults, the so-called timely processing is in accordance with the repair procedures, regular maintenance and maintenance machinery, all repairs and maintenance must be carried out in accordance with the requirements; in the course of use, should be strengthened. Timing and irregular inspection of the pulverizer and other pulverizers during use. The operation and temporary failure of the machine shall be dealt with in a timely manner, and the repair time shall not be delayed due to the minor fault, which has no influence on the operation and causes a large fault.
Second, the lubrication degree of Baozheng Machinery:
Normal lubrication is one of the effective ways to reduce mechanical failure. Therefore, the lubricant should be reasonably selected, the general lubricant type should be selected according to different types of machinery and application structure, and the appropriate quality group should be selected according to the requirements of the machine, and the appropriate quality grade should be selected according to the selection.
Third, the normal working load:
It should be noted that mechanical work cannot be performed under mechanically loaded loads. It is necessary to ensure an increase and a reduction in the mechanical load so that the machine is in a relatively slow load change. Specifically, it is to increase and decrease the throttle more evenly, and to avoid the lifting movement of the engine and the working device.

Address:Zhangjiagang Leyu Development Zone  电话:  MobilePhone:  E-mail: