PVC mill problem and its solution

The PVC mill incorporates computer control technology to make the device better adapt to the development trend of automation and provide strong driving force for the development of the industry. PVC mills may sometimes cause problems for various reasons. At this time, the operator is not primarily to contact professional maintenance personnel. Instead, he will try to solve the problem after completing the troubleshooting operation according to the method described below. No more contact with professional maintenance personnel.

A. Electromagnet problem. The problem with electromagnets is one of the "old problems" of PVC mills. After the device presents this problem, the operator can troubleshoot from the following aspects, including the internal host, solenoid coils, circuit problems, and so on. The first thing is to acknowledge whether the internal and external parts of the host are in normal working condition, and then check whether the coil of the electromagnet is blown. When there is no attack in the above situation, the operator should acknowledge that the circuit of the device is normal. .

B. Sensor problem. The sensor problem is the "old problem" of the second-largest PVC mill after electromagnet problems, usually caused by circuit faults. After encountering this problem, the operator can start from the view of the circuit condition to find the root cause of the problem and solve it.

Although in daily life, there may be a better maintenance work for the mill, it is still possible that the mill is damaged due to improper operation or wear of the parts.

The material is pulled off using a mill, perhaps the material itself has joints or burrs, and the unqualified fingertips are cleaned up. It may also be due to a problem with the paper feed motor circuit, which requires timely maintenance of the paper feed motor.