Zhangjiagang Leyu Yiyi Machinery Factory
Service Hotline:18706246515
Banner

What are the common problems encountered in the cutter grinding opportunity?

Edit:Zhangjiagang Leyu Yiyi Machinery FactoryUpDate:2018-02-01

We know that the cutter grinding machine replaces the traditional manual cutter grinding machine manufacturing, which makes our production and efficiency have a rapid improvement, but we need to pay attention to it, as a mechanical device, it will inevitably be used during the process. Some problems have arisen, so in order to improve work efficiency, let’s take a look at the problems that often occur when using the cutter mill.

1. Broken wire phenomenon occurs in the cutterhead mill:

Solution: First check the straightening block view to see if it is too big, or the knife can not retreat, the pressure spring on the wire feeding roller is too loose, the material is not good.

Second, the knife disc grinding machine has a phenomenon of bending:

Solution: You can adjust the viewpoint of the straight block to see if it is in line with the straightener and the rolling groove.

Third, the knife-grinding machine has a running phenomenon:

Check if the pressure spring is too tight, the slide spring is too loose, or the steel bar is not in place under the slide, and the slide does not slide. The cutterhead mill is attributed to an improvement in the structure of the cutterhead mill. Due to its high work efficiency, it is used in all major construction sites. There are four requirements for the protection of the cutterhead mill.

1. Regularity: The tools, workpieces and accessories of the cutterhead mill are placed regularly; the safety protection equipment is complete; the pipeline is complete.

2, safety: the implementation of fixed-machine setting and handover system; familiar with the equipment structure of the cutter-grinding machine and abide by the operating procedures, rational use of equipment, careful protection of equipment, to avoid attacks.

3, clearing: the cutter disc grinding machine equipment inside and outside cleaning; all sliding surfaces and screws, gears, racks, etc. without oil, no bumps; all parts do not leak oil, no water leakage, no air leakage, no leakage; The waste is cleaned clean.

4, smooth: on time for the cutter disc mill to refuel, oil quality meets the requirements; oil pot, oil gun, oil cup, linoleum, oil line clean completely, oil standard bright, oil road dredge.

In short, the equipment of the cutterhead mill must be carried out in strict accordance with the instructions, and it is not possible to voluntarily carry out the equipment according to its own. If the cutter disc mill has shortcomings in its operation, it will not only affect the power of the machine, but also affect the company's efficiency.


Address:Zhangjiagang Leyu Development Zone  电话:18706246515  MobilePhone:18706246515  E-mail:1360565135@qq.com

Mobile